At the moment on the guest (which hosts Windows Server 2008 64 bit), I have a LAN connection indicating that I should have an Internet connection, but no internet connection (a mess!). I tried tracert from within the virtual machine and after a while a series of time outs were displayed as well. I tried configuring the IP address manually within the Virtual Machine, and, even though the IP address is correctly marked as a duplicate (because another IP address is currently assigned over DHCP by the router), trying to PING the router results in a time-out. I tried re-installing Integration services again (although it was previously installed), and, although the NIC icon within the virtual machine shows as connected, I cannot even ping my router, so I'm back to square one. I noted that when I hit Disable within the LAN Properties (by accident), an error was displayed prompting me whether to reconnect, so somehow Hyper-V knows about the network interface, it is just that it does not show up within the virtual machine. ![]() These settings seem to have been faithfully copied to the NIC created while I was tinkering with the LAN connection settings. Will it work with one physical NIC? The NIC on the guest machine has an IP assigned manually from the Network Connections. The guest OS has one physical NIC though, although two physical NICs are recommended in John's article (the wording seems to indicate that it is not necessary, although I'm not sure about it). ![]() Well, I had created all three types attempting to have the network visible. I've been through the tutorials however, they do not seem to address the problem. VirtualBox Host-Only Network - not sure about this because both IPv4 and IPv6 are disabled, and, I don't think it's specifically mentioned in the "stuff I read". LAN 3 - I think this is a virtual network interface (IPv4 enabled IPv6 disabled) 3. LAN - Physical NIC (IPv4 enabled IPv6 disabled) 2. Vincent Hu The articles are interesting, and, within the virtual machine the Network is set to NVIDIA nForce networking Controller, whilst I have setup an external network (I think), because on the host computer there are three LAN connections: 1. How does basic networking work in Hyper-V? There are three Virtual Network in Hyper-V.įor more information, you can refer to the following articles: If you want to connect a VM to the network, you should create a Virtual Network. I suspect the root cause is the Network you connected to the VM. Instead of just going to the console editing a text file with nano and restarting the services, I DO have to use the web UI!?!? Horrible.Is this file " " the steps to create a VM? The former is for making the settings permanent, and the latter is for being able to access the web server again and finish the former. ![]() Then I quickly run back to my PC and reload the web UI, login and at the interfaces page, I do also set igb0 to that static IP there, so that the setting isn't temporary but saved into the mysterious settings file that I can't find.īottom line is I had to switch the IP from one interface to the other both in the web UI and in the console using ifconfig. Then I quickly run to the server, change the cable to the other port and set up igb0 with the static IP, so I can access the web UI again So no interfaces it must be for a short moment. I absolutely have to do this, because the web UI won't let me have both interfaces up with the same IP. Now that the web UI or whatever that processes name is thinks there's no interfaces, it clears the settings from the mysterious settings file that nobody seems to know where it's stored.I had to change the timeout from 60 seconds to something bigger because I'm not that fast of a runner So first of all I went into the web UI and removed the interface igb1.So after a few tries using ifconfig, I got it how I wanted it. Wow! What a freaking nightmare but this worked!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |